Project Detail

Description

So, I've been modifying a Flash file like I always do, but tonight I have a really inexplicable problem, and I need someone with an experienced eye to help me figure out what I'm doing wrong!

I have a MC called pages. Inside pages are 6 frames, one for each page's content.

On one page, I created a movie clip and use buttons to navigate between the frames of the movie clip, so that when you push the buttons, you get different content. Very simple on(release) with gotoAndStop(x); on the buttons, and a MC with an instance name and stop commands in the frames.

It works perfectly.

So, I go to the next page and try to setup the exact same thing, and, from what I can tell the Actionscript is all the same (but with a different internal MC and different instance names in the AS since it's not the same content).

So, now when I test the movie, the first page that I did this on still works great, but the buttons don't cause any change on the second page.

But the worst part is, I CAN'T FIND ANY DIFFERENCES!!! And, unfortunately, I'm losing my mind at this late hour...

If you can spare a minute to take a peek, I would be super appreciative!

ZIP with FLA can be downloaded here: http://www.trwdesigns.net/lockdown.zip

I'm putting $30-250 because that's the lowest it will go, but truly, I think $30 is a bit much for this problem. Take a look, and let me know what you think is reasonable to help me get this going right now!

Thanks,
Terrence