Project Detail

Firmware Development - STM32 Primer2

Firmware Development - STM32 Primer2 is project number 537974
posted at GetAFreelancer.com. Click here to post your own project.

| More

Status: Frozen
(Bid period finished)

Selected Providers: -

Budget: $750-1500

Created: 10/28/2009 at 6:14 EDT

Bid Count: 15

Average Bid:
$ 1632

11/17/2009 at 6:14 EST

Project Creator: deer777
Employer Rating: (No Feedback Yet)

Description

INTRODUCTION

The purpose of this document is to define the high level requirements for a firmware
development project of a sensor data collection system based on STM32 Primer 2 and ST
MEMS sensors.
This project description intends to define a design for a complete firmware, ready-to-use
for demonstration, operating on a system built from STM32 Primer2 and MEMS
accelerometers. The accelerometers are low-power 3-axis linear accelerometers with
digital output. The foreseen firmware needs to run an STM32 Primer2 device connecting
the sensing elements via an I2C interface, capable of translating information from a
numbeDesign Principles
This section provides the design principles with reasons driving these principles.
- Simplicity
-- Very simple, if possible the simplest solutions are preferred.
- I2C Bus
-- For the communication between the STM Primer The usage of I2C bus is flexible printed circuit board is required.
- Portability
The preference it to create a firmware, which is portable between STM32 and ST7
microcontrollers (both present on the STM32 Primer2 development platform)
Scope of Work
The following activities are in scope:
- Connection of Sensor
-- via Add-On Module [5] or
-- via breakout boards of MEMS sensors connecting to the E14 extension
connector of STM32 Primer2, similar to [6] (Please note, that this is a
different type of MEMS, although suitable for I2C integration development)
- Firmware development
- Testing

SCOPE
The following activities are out of scope:
- Application development

The following activities are limited to the necessary extent:
- Electronic advice, design and verification with regards to SMT32 Primer2

The following activities may be extended to the necessary extent:
- Advice on electronic design and verification with regards to replacing SMT32 Primer 2 with SMT32 Primer1
- Advice on electronic design and verification with regards to replacing the SMT32
Primer2 with an Atmel AVR based solution
... DETAILED PROJECT DESCRPTION ATTACHED

Additional files submitted:
STM32+Primer2+Fimware+Develpment++PA1.pdf

Report Violation

Messages Posted:1

If you are the project creator or one of the bidders Log In for more options

PMB

3000

30 days

10-31-2009 10:24 EDT

(No Feedback Yet)

Hello, We are a team of experts in system level product engineering services and we help customers with concept-to-manufacturing services. We have in-house electrical engineers, system architects, pcb lay out designers and complete hardware, software and testing capabilities. We can work with your system architects or provide you that service also. Average experience of engineers in our team is 15 years. We have extensive experience in developing micro-controller based solutions for several microcontrollers including Microchip, Motorola, Atmel, Philips, Cygnal. Please see PMB for futher details on the proposal

suman12

1500

45 days

10-28-2009 09:09 EDT

(No Feedback Yet)

pls. view PM

dheerajkatarya

2000

30 days

10-28-2009 09:14 EDT

(No Feedback Yet)

We have developed many application , device driver ,I2C driver on Linux platform If interested i can share demos of my previous work

EwenF

2000

30 days

10-28-2009 17:44 EDT

(No Feedback Yet)

I have many years experience designing with accelerometers from several manufacturers including ST LIS3L02 and LIS344AL. The I2C interface is also no problem.

tipu04

975

20 days

10-29-2009 01:09 EDT

(No Feedback Yet)

I am well experienced in serial bus interfaces and can implement it on ARM .

aprajam

1500

40 days

10-29-2009 05:22 EDT

(No Feedback Yet)

I have exp with firmware development for micro controllers. I have good exposure to I2C and have implemented I2C protocol in firmware for powerpc processor and also 8051 micro controllers.

dancu

1400

30 days

10-31-2009 08:46 EDT

(No Feedback Yet)

Dear Mr. Gelencser, I just finished my work as junior research assistant at the Embedded Systems Laboratory of National University of Singapore. I have just signed up on this site and have no feedback yet, but I would like to improve on this by completing this project profieciently. I look forward to working and cooperating with you. I have attached one of my favorite projects which I created for the Image Processing lecture. Best regards, Alex

Maryvale

1500

21 days

11-01-2009 01:11 EDT

(No Feedback Yet)

Hi, I'm very interested in your project. Please see the PM. Thanks.

henryjr

3000

60 days

11-01-2009 22:20 EST

(No Feedback Yet)

Dear Srs.. I m Expert in microcontrollers and embedded systems... please contacte for determinate the specific job. thanns

rapidsoft

1500

30 days

11-02-2009 04:59 EST

(No Feedback Yet)

Rapidsoft Systems is an outsourced software product development company based in Princeton, New Jersey with software development activities in the USA and India. We are a foremost outsourced software product company with expertise in Online Gaming Software, Web applications, Mobile applications, enterprise applications development, etc. Our team of engineers have executed over 350+ major projects amounting to over 1,200,000 effective hours in all areas for all kind of companies from individual start-ups to Fortune 500 businesses. Our team of expert will provide you the solution for Full Device Driver support for LINUX, WINDOWS, WINCE,SYMBAIN. Demo is available on demand.

stemtechnologies

1500

60 days

11-04-2009 21:50 EST

(No Feedback Yet)

We are a group experienced embedded engineers working on hardware and software projects. We can do you project. We have given more info in the PM Regards Somasundaram.I

dasanupam

1700

120 days

11-13-2009 12:06 EST

(No Feedback Yet)

i think i can able to do that.

freshmind123

999

30 days

11-16-2009 14:18 EST

(No Feedback Yet)

Please check PM. regards

makinmakin

1000

25 days

11-16-2009 16:34 EST

(No Feedback Yet)

See details in MB.

fathahrahman

900

30 days

11-17-2009 05:34 EST

(No Feedback Yet)

Please see the PM and project clarification board

Bid on this Project

WHAT IS FREELANCER.COM?

Freelancer.com is a global outsourcing solution and freelance jobs website. Here you can find freelance coders, writers, programmers, designers, marketers and more. You can also outsource projects and save a lot of money in the process. Getting the best web design, professional programming, custom writing or affordable marketing has never been easier!

We have thousands of satisfied clients from every corner of the world. Would you like to outsource your next project? Would you like to find freelance jobs and make money online? Just sign up to get started! Outsourcing jobs is the process of hiring an outside company or individual to complete your projects. We have created a safe environment for both service buyers and service providers via our secure payment system. You outsource the project and don't release any money until you're satisfied! Try outsourcing for free today! Don't forget to bookmark our homepage for your next project or job.